Lawrie,
Thanks for the advice.
I need to clarify the 1/8" problem, though. I guess I should have said
length when I said width. When I set a main bearing into the block,
the bearing does not seat all the way down into the block. there is a
1/8" gap between the bearing and the seat in the block. It is like the
bearing is "bridging" it's respective block cavity. I am sure I could
press the bearing half down into the block but wanted to confirm that
this is normal before I did so.
Thanks, Ray
Subject: Re: Let's Try it Out
Author: "Lawrie Alexander" <Lawrie@britcars.com> at wg-ral-smtp
Date: 3/30/98 7:35 AM
Ray...this is a common problem with the new center main bearings sold today.
The fix, however, is simple....
First, the locating hole......a small rattail file should be used to
carefully ovalize the hole until it fits over the locating dowel in such a
way as to enable the bearing flanges to fit the saddle correctly.
Second, the fit into the crankshaft.......this will need a pair of calipers,
a set of feeler gauges, some 400grit wet/dry paper, a can of WD40 and a
surface plate (or piece of window glass laid flat and taped down so it can't
move). Measure the width of the bearing at each end and in the middle.
Determine which is the forward side of the bearing (toward the front of the
engine) when it is installed. Spray a patch of the paper with WD 40, then
rub the forward edge of the bearing - making sure your pressure is even
across the full width of the bearing - on the paper. Spray fresh WD40 from
time to time.
Keep checking with your caliper to make sure you are taking the metal off
evenly. Keep trying the bearing in the crank until it will fit and allow you
to place a three-thousandths feeler gauge all the way around. Repeat the
process on the other bearing half, making sure you remove metal only from the
forward side of that half, too.
Lawrie
British Sportscar Center
-----Original Message-----
From: ray.rockwell@wg.com <ray.rockwell@wg.com>
To: mg-t@autox.team.net <mg-t@autox.team.net>
Date: Monday, March 30, 1998 5:06 AM
Subject: Let's Try it Out
>
> Let's see if there is anyone out there (yet) that can advise me on a
> TECHNICAL QUESTION.
>
> I have 53TD, with the engine just out of the machine shop. Put the
> cam in and now is on the stand. Since I could not get anywhere with my
> engine due to problem below, I decided to sandblast the entire frame
> this weekend then prime and paint it. Turned out pretty good.
>
> I am following Horst Schach's book cover to cover but he leaves out
> many things, commonly called details. Anyway, my question is
>
> I am attempting to put the main bearings in and there is about a 1/8"
> gap between the bearing and the cap or block (bearing too wide). I did
> not want to force the bearings in just yet. Is this normal? Also, the
> center bearing goes in OK over the dowel pin in the block but the
> edges of the bearing do not quite line up even with the edges in the
> block. Is this normal?
>
> Thanks in advance.
>
> Ray Rockwell
> Cary, NC
>
>
|