Terry,
That's the way my J2 was. Alternately, mount the rear via gearbox or
cross-shaft (I'm not sure of the configuration on the NA), then lift the
engine and bolt the front mount to the engine. Does that make any sense?
Cheers,
Lew
-----Original Message-----
From: owner-mg-mmm@autox.team.net [mailto:owner-mg-mmm@autox.team.net] On
Behalf Of TATERRY@aol.com
Sent: Tuesday, July 26, 2005 7:53 PM
To: mg-mmm@autox.team.net
Subject: Engine installation?
Gents, I'm about ready to trial fit the engine into the old NA....I see that
the radiator/front motor mount is very close to the cross member requiring,
I
think, that it be mounted on the front of the motor first and then the motor
put down into the chassis, then lifted up into position.....is this
correct??
Terry
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|