Gents, one of the two little hinge points for the reverse gear lock out is
broken off on my shifter tower. I have the broken piece and tried to solder it
back on using some magical alloy solder that Bill Trail picked up at a swap
meet. This didn't work so now I'm trying JB Weld....but do you have any other
thoughts about re attaching this little pivot post??
Did I see somewhere that this tower for P's and N's has been reproduced?
Tnx
Terry
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|