I've fitted 12 inch brakes to my J2 and they work a treat
BUT.....they foul the wheel arch. The nuts of the brake
shoe pivot pins have gouged about 1/8 of an inch out of the
wheel arch-it is down to the ply in one place. Has anyone
found an easy solution to this? I can cut the body work
away easily enough but then will be left with a raw edge of
aluminium and ply-how can I finish it off. I don't think
that I can cut the ply and leave enough aluminium to reform
the bottom of the wheel arch as it is at present. Anyway
the aluminium will be work hardened I guess. Any solutions
that don't involve taking the body off and starting again
would be appreciated. Thanks.
----------------------
David Stansbie
David.Stansbie@bristol.ac.uk
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|