Re: Clutch Pedal Removal - P Type

["Peter Green" <p.green@mgk3.co.uk>]

Chris,

I presume you are talking about the pins that hold the sleeves on the cross
shaft that hold the rubber bushes in the bell housing in place, if so they
are tapered and will only come out one way. More often than not the thin end
of the taper has been peened over to stop it coming loose/out.

Regards,

Peter Green


----- Original Message ----- 
From: "Chris Bucknell" <c.bucknell@bigpond.com>
To: "MMM List" <mg-mmm@Autox.Team.Net>
Sent: Wednesday, October 06, 2004 12:56 PM
Subject: Clutch Pedal Removal - P Type


> Hi All,
>
> I am wanting to know how to remove the clutch pedal from its shaft on our
> P-Type.  Any hints or tips would be most appreciated.
>
> Also any hints or tips on removing the locating pins from the cross shaft
> that
> supports the gearbox on a P. As well as any thoughts on why the pins are
> there
> at all/do they need to be?
>
> Regards,
>
> Chris Bucknell
> Australia
> P-Type/R-Type Driver
>
> ///  unsubscribe/change address requests to majordomo@autox.team.net  or
> try
> ///  http://www.team.net/cgi-bin/majorcool
> ///  http://www.team.net/mailman/listinfo
> ///  Archives at http://www.team.net/archive/mg-mmm
> ///  Send list postings to mg-mmm@autox.team.net
///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/cgi-bin/majorcool
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/mg-mmm
///  Send list postings to mg-mmm@autox.team.net