Re: Mandrel for front bearing housing alignment

["Dave & Diana Dwyer" <dmdwyer@optusnet.com.au>]

Alex

I aligned mine using a clock guage mounted onto the top fork of the dynamo,
and reading the inside face of the VD bearing hole in the front of the head.

As I recall the figure to aim for is about 2 thou #max# of centre. Note that
you will probably have to move the front housing in the fore and aft
direction as well as rotating it.

Regards

Dave Dwyer
J2, TA, TC
Sydney

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/cgi-bin/majorcool
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/mg-mmm
///  Send list postings to mg-mmm@autox.team.net