In a message dated 5/6/03 06:02:16 Pacific Daylight Time, DENKLEMM@aol.com
writes:
<< The clutch spigot bearing (ball bearing mounted to the flywheel) appears
not
to be lubricated. Is this correct or should a small amount of grease by
applied during assembly? >>
Dennis, I recommend that you use a permanently sealed, prelubricated
bearing.....your local bearing dealer can get one for you. Definitely not
dry!
Terry
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|