Yes, please. All I need to know is how the ends of the fender and
running board are formed. I assume there is a vertical piece in the end
of each to which they bolt to one another. But, I wouldn't know as there
were none on mine, whatsoever, simply a piece of sheet metal pop riveted
over the joint. Also, the width of one fender seems wider than the
running board, as the splice between the two on that side tapers
significantly.
-----Original Message-----
From: DENKLEMM@aol.com [mailto:DENKLEMM@aol.com]
Sent: Tuesday, September 24, 2002 8:54 PM
To: Lew Palmer
Subject: Re: P-type Fenders (Wings) and Running Boards
Lew
My PA is apart (came to me that way), I can photograph the pieces, but
don't know how correct they are. Let me know if you want me to shoot.
Cheers
Dennis Klemm
PA1518
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|