Jarl
<Phil Marino's tapered-end axle rear modification.>
But surely it's still necessary to replace one of the two bits, at least? Or
is there an insert fitted to the hub to accept a taper ground on the old
halfshaft? As you'll gather I don't know anyone who has the mod.
The reason for my original comment was dismiss any thoughts of using the
existing parts with welding, screws, Loctite, etc, which have all been tried
and failed in the past.
Regards
Dave Dwyer
J2, TA, TC
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|