In a message dated 8/5/02 19:44:01 Pacific Daylight Time, DENKLEMM@aol.com
writes:
<< I have removed the nuts, should I be able to
just drive the pins out or do they have to unscrew? I can't seem to turn or
drive them out. Can I apply some heat? >>
Dennis....put the nuts back on and leave them a little loose, then bang on
the nut until the slack is taken up, then repeat the process until you have
it ready to pull out. Its a tapered pin......no threads......heat as a last
resort.....
Terry
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|