Message text written by "Lance Wayman"
>As an M type owner, I am curious as to what is involved in changing
the crankshaft and con rods. Are you using the 2 main bearing shaft?
Any and all information on improving the engine would be appreciated.
<
Dont know what you mean!
basically
Remove engine
Take engine apart
Remove old crank and rods
fit new and reassemble
What else you do depends on what crank what rods etc etc. You
cant do other than to use a 2 bearing crank on an M/D/J engine
There is a LOT of fettling to be done usually to get the bigger rods
to clear the block etc.
Clive
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|