Bill,
If you have no success in the North try the following.
<A
HREF="http://aolsvc.yp.aol.com/detail.adp?stabs=0&smax=1&sview=distance&setid
=0&expand=&letter=&skip=0&map=0&cid=100239190&city=Long%20Beach&state=CA&lat=
338025&long=%2d1181851&zip=90806&myaddr=&cat=&namesearch=long%20beach%20sprin
g&referer=&address=&dma=5">Long Beach Spring</A>
1000 E Spring St
Long Beach, CA
562-427-3336
I used them around '88. Two rear main leaf springs, eyes larger, brass
bushings
7/8"od. 5/8"id. inserted. $90.00 plus tax. They did have the correct width
sprung steel in stock at that time. I have checked their number and address,
it's still current.
As Bob suggested, I gave them the Blower measurements.
Brian Kelly.
In a message dated 03/04/2002 3:19:51 PM Central Standard Time,
bill@clovermachine.com writes:
> I asked my local spring shop to make new main leaves for my J2
> as the trunnion has warn them down considerably. They said no as
> they didn't stock narrow material...just big Detroit iron type spring
> material. Couldn't shear it, wouldn't flame cut it (warpage, heat treat
> and grind edge) and didn't have enough usage for a minimum order.
>
> I made custon fit trunnions from phospher bronze, but would rather
> have new spring leaves.....Anyone know of an accommodating
> shop in Northern California?
>
> Bill Traill
> J2#3343
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|