Lew
The wiring is almost the same with the D and F terminal from the generator
going to the D & F terminal of the control box. The F1 & F2 wires that go to
the lighting switch are not used.
Jerry
Lew Palmer wrote:
> Jerry,
>
> OK, now you've gotten my curiosity up. I've always understood that a
> three-brush dynamo could not be used with a regulator. Or is this just
> urban legend?
>
> Perhaps you could share a bit more detail. I'm curious how this is
> wired, as I'd sure like to use a better setup than a cutout with the
> DDS14.
>
> Regards,
> Lew Palmer
>
> -----Original Message-----
> From: owner-mg-mmm@autox.team.net [mailto:owner-mg-mmm@autox.team.net]
> On Behalf Of Gerald Felper
> Sent: Wednesday, January 30, 2002 11:30 AM
> To: Lew Palmer
> Cc: Kellmg@aol.com; mg-mmm@autox.team.net
> Subject: Re: fuse box-cutout PA
>
> Lew & Brain
> The two coil regulator can be used with the three brush generators.
> Jerry Felper
>
> Lew Palmer wrote:
>
> > Don and Brian.
> >
> > My Lucas catalog shows the same thing. The RJF2 is a regulator, not a
> > cutout. I will have two coils, not one, and is used in conjunction
> with
> > a standard two-brush dynamo, not the 3-brush unit as normally fitted
> to
> > the Triple-M cars.
> >
> > I seem to remember that there is an article somewhere (MMM Yearbook?)
> > that describes converting to a two-brush dynamo.
> >
> > But, as it stands, do not try to use the RJF2 with the standard DDS14
> > dynamo.
> >
> > Regards,
> > Lew Palmer
> >
> > -----Original Message-----
> > From: owner-mg-mmm@autox.team.net [mailto:owner-mg-mmm@autox.team.net]
> > On Behalf Of Kellmg@aol.com
> > Sent: Tuesday, January 29, 2002 4:34 PM
> > To: mg-mmm@autox.team.net
> > Subject: Re: fuse box-cutout PA
> >
> > Hi Don,
> >
> > All I can tell you is the fact that it is listed in the 1935 Lucas
> cat.
> > So,
> > your assumptions should be correct. The 337571 is the ordering number
> of
> > the
> > complete unit. The cat. doesn't cross reference units so, I can't be
> of
> > any
> > extra help.
> > >From a 1946 cat. it leads you to believe that,
> > CJR incorporates Cutout, Junction box, Fuses
> > RJF incorporates Regulator, Junction box, Fuses.
> >
> > Does your RFJ 2 have more than one relay in it. The RFJ, I imagine
> reads
> > Regulator, Fuses, Junction box. If this is the case you would have a
> > cutout
> > and a regulating coil in the upper portion. ??? If this is the case
> it
> > wouldn't have incorporated the third brush style dynamo.
> >
> > Brian Kelly.
> > In a message dated 01/29/2002 3:07:41 PM Central Standard Time,
> > DSBonar@aol.com writes:
> >
> > > I have been given a Lucas RJF2 Type L 10 for use on PA 1823.
> According
> > to
> > > Moss catalog, PA should have a Lucas CJR 2. Since I don't have the
> > original
> > > I
> > > have no way to compare.
> > >
> > > On the cover is reads:
> > >
> > > RJF2 Type L 10
> > > 337571
> > > 12V ER 10 34
> > > (assuming serial #, 12 volt made October of 1934)?
> > >
> > > On a paper fuse guide under fuses on the "bottom or ... against the
> > > firewall"
> > > of the unit is printed:
> > >
> > > CJR 3 - 336194
> > >
> > > Can one of you fuse experts tell me what I have and will it
> substitute
> >
> > > properly?
> > >
> > > Thanks
> > >
> > > Don B
> > >
> > > ///
> >
> > /// unsubscribe/change address requests to majordomo@autox.team.net
> or
> > try
> > /// http://www.team.net/cgi-bin/majorcool
> > /// http://www.team.net/mailman/listinfo
> > /// Archives at http://www.team.net/archive/mg-mmm
> > /// Send list postings to mg-mmm@autox.team.net
> >
> > /// unsubscribe/change address requests to majordomo@autox.team.net
> or try
> > /// http://www.team.net/cgi-bin/majorcool
> > /// http://www.team.net/mailman/listinfo
> > /// Archives at http://www.team.net/archive/mg-mmm
> > /// Send list postings to mg-mmm@autox.team.net
>
> /// unsubscribe/change address requests to majordomo@autox.team.net or
> try
> /// http://www.team.net/cgi-bin/majorcool
> /// http://www.team.net/mailman/listinfo
> /// Archives at http://www.team.net/archive/mg-mmm
> /// Send list postings to mg-mmm@autox.team.net
>
> /// unsubscribe/change address requests to majordomo@autox.team.net or try
> /// http://www.team.net/cgi-bin/majorcool
> /// http://www.team.net/mailman/listinfo
> /// Archives at http://www.team.net/archive/mg-mmm
> /// Send list postings to mg-mmm@autox.team.net
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|