MG PA engine

[Dwyer <jasper@enternet.com.au>]

Gentlemen

I've just started to reassemble the rocker and camgear and I've realised
there are a couple of things that I don't know about it:

1.      The rocker shafts have a row of oil holes to feed the rockers: do
these holes point toward the centreline of the head, or out to the
sides?

2.      The rocker bushes will fit into the rockers from either side: which
side should the hex heads be? I realise that it might not matter, but I
might as well put them the way the factory did if possible.

All advice greatfully accepted.

Dave Dwyer
Sydney