--openmail-part-04939c44-00000001
Content-Disposition: inline; filename="BDY.TXT"
;Creation-Date="Tue, 8 Aug 2000 07:52:35 +0100"
Dear All,
I was concerned to read Terry's message which suggested that there
might be a problem with the well-regarded Phoenix products. My concern
was based on self-interest as my PB engine (yet to be fired up for the
first time) has been assembled with a Phoenix crank and rods.
Enquiry from a source with very direct knowledge of Phoenix and their
business reveals that there was indeed a failure of a MMM racing engine
in the USA within the last year resulting from a rod bolt failure.
Tests conducted show that the failure occurred because the single-use
stretch bolts had been overtightened well beyond the recommended
torque, which I understand (but please check with Phoenix) is 35 foot
pounds.
As to rumours of the imminent demise of Phoenix - I am assured that
there is no basis of fact behind this story. Mark Twain had a similar
experience, I gather.
The MMM bulletin board is a veritable mine of information, but I felt
moved to respond on this occasion because I know only too well the
damage - however unintended - that can be caused overnight to
reputations that have been hard-earned over years.
I should add a disclaimer that I have no relationship with Phoenix
other than being a (so far) satisfied customer.
Regards to all
Dick Morbey
-----Original Message-----
From: TATERRY@aol.com [mailto:TATERRY@aol.com]
Sent: 04 August 2000 16:28
To: mg-mmm@autox.team.net
Cc: TATERRY@aol.com
Subject: Phoenix connecting rod bolts
Dear Prewarriors, a note of caution! From an extremely reliable
source,
I've learned that the results of an independent engineering failure
analysis
said that rod bolts heat treated by Phoenix in early 1999 resulted in a
faulty batch!! and that was the direct cause of a catastrophic failure
of a
MMM engine of some note.
It was also said that Phoenix is going to fold up in 2001.
This information is second hand and not collaborated by any
documentation.
It is not my purpose to spread rumors and my information is that
Phoenix has
always manufactured a very high quality product. Being in the rolling
stock
business, I know first hand how easily something like this can happen
by an
outside vendor. So just to caution that if you have rod bolts
installed in
your engine that may have come from this batch, you'd be advised to
replace
them....that would be January or February of 1999.
Terry
**************************************************
The information contained in this email is intended only for the person or
entity to whom it is addressed and may contain confidential and/or privileged
material. If you have received this email in error please note that any
review, retransmission, copying, dissemination or other use of, or taking of
any action in reliance upon its contents is prohibited. Please contact Taylor
Woodrow on +44 (0)20 8575 4811, or send an email to helpdesk@taywood.co.uk if
you are not an intended recipient and delete the material from any computer.
Thank you.
The contents of an attachment to this email may contain software viruses which
could damage your computer system. We cannot accept liability for any damage
which you sustain as a result of software viruses. You should carry out your
own virus checks before opening any attachment.
--openmail-part-04939c44-00000001--
|