I am in the process of fabricating an adapter plate to change from one
block bell housing pattern to another. yeah, I could have bough tone but
the price was $695 bucks so I am making it myself. The question,
however, is about mid engine support plates. The metal plate I am using
is wide enough touse as a mid motor plate, but what's the experience out
there regards the efficacy of such a thing? If I use a mid mounting
plate, should I use the trans mount? I use a large AOD for a trans so
there would be a lot of weight cantilevered back there if I don't. And
I don't use a front mount plate either although that could be done.
So, comments on the use of a mid plate?
mayf
--
______________________________
drmayf
Worlds Fastest Sunbeam, period.
204.913 mph flying mile
210.779 mph exit speed
_______________________________________________
Land-speed@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|