Hi Doc
Most of my motors have had piston down in the bore at least .010".
A lifetime ago I built a turbo motor with .160"piston to deck, to get
compression lower, and it ran just fine and made more power than I expected.
Speeds suggest around 400 HP from 2.5L. While this is nothing by today's
standards
My uneducated guess is that even with the smallish turbo I was using then,
just created so much inlet turbulence that the piston
position/squish/quench became less important.
Now in later years the same engine with a properly designed piston with a
large enough sump to get compression down to where I wanted, made lots more
power, but many other parts had been changed as well. Wayyyy more power.
So, I'm gonna say for a street engine of some unknown HP. down in the bore a
little (like .060") probably would be just fine........
go for it..........and have some fun
_______________________________________________
Land-speed@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|