As a machinist I would recommend useing a thread gauge when you tap the
holes too, so you have the correct engagement. doug
----- Original Message -----
From: "Kirkwood" <saltfever@comcast.net>
To: "land-speed" <land-speed@autox.team.net>
Sent: Saturday, January 23, 2010 4:25 PM
Subject: [Land-speed] Tire Valves
> Thanks, JT. . . good idea. I also checked the Machinery's handbook and
> the
> recommended engagement for hand tight is .161'' which is about 4-5
> threads.
> For high pressure they say ''longer thread engagement is used'' but give
> no
> recommendation. Me thinks added thickness is a good idea.
>
> From: Joe Timney <joetimney@dol.net>
>
> Wall thickness concerns...add two bosses, 180 degrees apart on the inside
> of
> rim, drill and tap one and balance the rim before adding the tire.
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Land-speed mailing list
>
> You are subscribed as daw1@comcast.net
>
> http://autox.team.net/mailman/listinfo/land-speed
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Land-speed mailing list
http://autox.team.net/mailman/listinfo/land-speed
|