land-speed
[Top] [All Lists]

Re: [Land-speed] Blade Type Male Connector Pins

To: <drmayf@mayfco.com>
Subject: Re: [Land-speed] Blade Type Male Connector Pins
From: "23weldon" <23.weldon@comcast.net>
Date: Sat, 28 Nov 2009 17:30:55 -0800
Mayf -- If you strike out on a source you may have to make your own from 
sheet phosphor bronze like the model train guys use or berrylium copper. 
What's the thickness you need?  I could mail you some sheet if it matches 
the sizes in my shop stock.
Ed Weldon
----- Original Message ----- 
From: "drmayf" <drmayf@mayfco.com>
To: "LSR" <land-speed@autox.team.net>
Sent: Saturday, November 28, 2009 5:01 PM
Subject: [Land-speed] Blade Type Male Connector Pins


> Well, time to start the dumb questions.    I am in need of  some Ford 
> Connector pins. I want to make some extender test cables for my EFI 
> harness in the Sunbeam.  I can find and have some   round pins that will 
> work for three of the sensor cables but two sensors and the fuel injectors 
> have eluded me. These are blade type pins which appear to be about 2.5 mm 
> wide and fairly thin. Like a skinny push on type but skinnier and longer. 
> I have looked at Motorcraft connectors, FordFuelInjection.com, 
> Delphi-Packard, Digikey, Allied Electronics and Waytek Wire.   For you 
> ford guys, pin examples are the Mass air flow sensor pins, the TFI sensor 
> pins, and for all of you the fuel injector pins. These are all flat pins. 
> I can find the female parts but so far, no male pieces.  Any of you guys 
> have a favorite source that might have these kinds of pins?
>
> Many thanks
>
> mayf
> _______________________________________________
> Support Team.Net  http://www.team.net/donate.html
>
> Land-speed mailing list
>
> You are subscribed as 23.weldon@comcast.net
>
> http://autox.team.net/mailman/listinfo/land-speed
_______________________________________________
Support Team.Net  http://www.team.net/donate.html

Land-speed mailing list


http://autox.team.net/mailman/listinfo/land-speed

<Prev in Thread] Current Thread [Next in Thread>