Sparky
In the 60's on the dragster axles I think I used to just put 3/4" x 3" (?)
bars behind the bearing on the press . If yours have the steel ring pressed
on inside the bearing it takes less force if you remove them first by
splitting them with a chisel .
> anyone have suggestions for a source for the special tool for use with the
> press for this job?
> _______________________________________________
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Land-speed mailing list
http://autox.team.net/mailman/listinfo/land-speed
|