You can buy Ford crate engines with a lot of cam. What are the specs on
that cam?
Bryan
drmayf wrote:
> I spent 17 hours this week end with another guy and we made some very
> good progress on the truck. Itseemed that everything we touched had
> to be redone in some form or fashion. After being tolf that the
> exhaust manifolds, the cast iron ones, were the same as what came off
> the truck to begin with, when trying to fit up the down pipes, fout
> out otherwise. Finally located a y pipe that fir the motor with odd
> manifolds, but no O2 bung. Some connectors not connected. Late
> yesterday found a connector a the far back end of the manifold not
> connected. Suspect it is for a knock sensor but this block has no
> knock sensor threaded hole location. The engine runs great above 2000
> rpm. Runs like crap at 1000 rpm. I have run out of ideas and gumption
> in working on this thing. If there are any other ideas about why it
> would not run at 1000 but runs like a scalded dog at 2000 lemme know
> and I will pass it along..
>
> See ya'll on the salt...
>
> mayf
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Land-speed mailing list
>
> You are subscribed as b.a.savage@wildblue.net
>
> http://autox.team.net/mailman/listinfo/land-speed
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Land-speed mailing list
http://autox.team.net/mailman/listinfo/land-speed
|