Jim
Assuming it won't change dimensions for throw out bearing movement to be a
problem.
OK
But use the Ultra Black RTV.
It was/is designed to be used in an oily environment and will work even if
the surfaces are not operating room clean.
That doesn't mean don't make the mating surfaces squeaky clean.
You don't have to wait for the RTV to skin over. I apply a small bead, and
"butter it on with my finger tip, then assemble. Wait for overnight for
cure time then cut with exacto the excess material that squeezes out. Doing
it this way, you don't get too much material squeeze on the inside of the
surface where it can fall off and get into moving parts or block the drain
passage.
Best regards
----- Original Message -----
From: "Jim Dincau" <jdincau@qnet.com>
To: "land Speed List" <land-speed@autox.team.net>
Sent: Thursday, November 27, 2008 10:03 PM
Subject: [Land-speed] Borg Warner super T-10 trans.
> Hi all,
> On the subject trans. can I substitute silicone or Hylomar for the
> front bearing retainer gasket?
> Jim in Palmdale _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Land-speed mailing list
>
> You are subscribed as rick@rbmotorsports.com
>
> http://autox.team.net/mailman/listinfo/land-speed
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Land-speed mailing list
http://autox.team.net/mailman/listinfo/land-speed
|