Rick -- To try and estimate an oil flow rate for each cylinder on the turbo
Ford 2.3 engine can you answer some questions?
1. What was the size of each the oil "nozzle"; i.e. cossectional area?
2. What SAE grade oil and rough estimate of oil temp during run?
3. What oil pressure?
4. Rough estimate of HP at power peak?
This'll help with some rough heat transfer calcs.
thanks, Ed Weldon
----- Original Message -----
From: "Rick Byrnes" <Rick@RBMotorsports.com>
To: "Ed Weldon" <23.weldon@comcast.net>; "Bryan Savage"
<b.a.savage@wildblue.net>; <karlepayne55@yahoo.com>; "land Speed List"
<land-speed@autox.team.net>
Cc: "land-speed-digest" <land-speed@autox.team.net>; <jgmagoo@comcast.net>
Sent: Thursday, October 02, 2008 8:24 AM
Subject: Re: [Land-speed] 1750 EGT>From>JGMagoo
> I used oil squirters on my turbo Ford 2.3 engines in the Merk and will do
so
> again when I start adding POP to the N/A combination.
(snip)
> Rick
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Land-speed mailing list
http://autox.team.net/mailman/listinfo/land-speed
|