In a message dated 7/14/2008 2:04:27 P.M. Eastern Daylight Time,
land-speed-request@autox.team.net writes:
> From: "drmayf" <drmayf@mayfco.com>
> To: "LSR" <land-speed@autox.team.net>
> Sent: Sunday, July 13, 2008 9:23 AM
> Subject: [Land-speed] Need a Shade Tree Repair Method..
>
>
> > Yesterday after running the SUnbeam fora few minutes I noticed that it
> > was dumping out the wastegates port at idle. Since I have had some
> > issues with wastegates before I started isolating the problem. I found
> > it thankfully in only one of the gates. And fourtunately the easiest one
> > to remove. The diaphram that moves the valve open and closed has a small
> > hole in it. That releases the air from the bottom side to the top side
> > of the diaphram causing that one to be essentially stuck closed all the
> > time.. That same plumbing system controls the other unit as well.
> >
> > So the removed the offensive unit and tore into it. The piston inside
> > has a sharpmetal edge that did the evil deed as the vlve opened and
> > closed. The real issue is that this is a chinese unit (yeah, I am a
> > cheap SOB, so get over it) and replacement parts are non existent. I
> > have ordered a couple more gates and they should be here in a week or so.
> >
> > The question is, do any of you have any iideas on how to repair a red
> > silicone material or know of any items like high temp tape that would
> > work to plug this small hole? If the darned this was made of rubber like
> > a bicycle inner tube, I would just use a patch on it. But is a silicone
> > material and hardly anything really sticks to it. And this area gets
> > hot so it needs to be capable of around 500dF or so.
> >
> > I just need suggestions or methods to repair this, so don't get crazy
> > and tell me I am a dumb sh*t for buying this junk to begin with, yada,
> > yada...
> >
> > Any helpful ideas out there?
> >
> > mayf
Use the red high temp silicone that the part store sells. It's made to seal
catalytic convertors. We use it on headers all the time in place of gaskets.
Worth a try. I've used it on jag carb diaphragms.
bob
**************Get the scoop on last night's hottest shows and the live music
scene in your area - Check out TourTracker.com!
(http://www.tourtracker.com?NCID=aolmus00050000000112)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Land-speed mailing list
http://autox.team.net/mailman/listinfo/land-speed
|