land-speed
[Top] [All Lists]

[Land-speed] Need a Shade Tree Repair Method..

To: LSR <land-speed@autox.team.net>
Subject: [Land-speed] Need a Shade Tree Repair Method..
From: drmayf <drmayf@mayfco.com>
Date: Sun, 13 Jul 2008 08:23:11 -0700
Yesterday after running the SUnbeam fora few minutes I noticed that it 
was dumping out the wastegates port at idle. Since I have had some 
issues with wastegates before I started isolating the problem. I found 
it thankfully in only one of the gates. And fourtunately the easiest one 
to remove. The diaphram that moves the valve open and closed has a small 
hole in it. That releases the air from the bottom side to the top side 
of the diaphram causing that one to be essentially stuck closed all the 
time.. That same plumbing system controls the other unit as well. 

So the removed the offensive unit and tore into it. The piston inside 
has a sharpmetal edge that did the evil deed as the vlve opened and 
closed.  The real issue is that this is a chinese unit (yeah, I am a 
cheap SOB, so get over it) and replacement parts are non existent. I 
have ordered a couple more gates and they should be here in a week or so.

The question is, do any of you have any iideas on how to repair a red 
silicone material or know of any items like high temp tape that would 
work to plug this small hole? If the darned this was made of rubber like 
a bicycle inner tube, I would just use a patch on it. But is a silicone 
material and hardly anything really sticks to it.  And this area gets  
hot so it needs to be capable of around 500dF or so.

I just need suggestions or methods to repair this, so don't get crazy 
and tell me I am a dumb sh*t for buying this junk to begin with, yada, 
yada...

Anh helpful ideas out there?

mayf
_______________________________________________
Support Team.Net  http://www.team.net/donate.html

Land-speed mailing list


http://autox.team.net/mailman/listinfo/land-speed

<Prev in Thread] Current Thread [Next in Thread>