Dick;
If I had a very heavy load I'd think about splitting the system into
branches; this way each branch can deal with lower current.
Regards, Neil Tucson, AZ
-----Original Message-----
From: land-speed-bounces+neil=dbelltech.com@autox.team.net
[mailto:land-speed-bounces+neil=dbelltech.com@autox.team.net] On Behalf Of
Dick J
Sent: Saturday, April 12, 2008 7:30 AM
To: lsr list autox
Subject: [Land-speed] Electrical Wiring in Race Car
Does anybody know of a website that has a reference chart on wire sizes
needed to wire a car. Maybe a street rod site or something. I'm re-wiring
my race car and need some help. I'm not too concerned with wire sizes to
each device, as most of them had pigtails and I figure I can just use the
same size or next size larger. I even have instructions left for some items.
I'm concerned with what size lead I need going to the master fuse panel. I
need to supply a monster fuel pump, three cooling fans, the ignition,
electric water pump, etc. Originally, I took all of the individual leads
directly off of a master disconnect switch, so they were supplied directly
from a battery cable. Now, I'm going to go from the master switch to a fuse
panel, and then to individual toggles. What size wire needs to supply that
fuse panel?
thanks
DickJ
In east Texas
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Land-speed mailing list
http://autox.team.net/mailman/listinfo/land-speed
|