I want to try and be compliant with the new rules abot having less than
2 inches side movement of the helmet. I think the rule is flawed, but I
don't get a vote so I want to build a better supprt. I see the nascar
seats have a pair of "horns" attached to that the helmet cannot rattle
from side to side. I want to add something like that to my roll cage. a
piece of flat aluminum bar stock that goes from the front bar back to
the rear vertical bars on each side. Then I will put some foam pad on
it. I think you can buy the SFI stuff in flat sheets and that may be my
answer for padding. Question - how wide should this bar be? 1 inch? 2"
Or More? How thick? 1/8 inch? 3/16"? 1/4" or more? Thoughts or
comments? No I am not going to creplace my seat with one of one of
thoses. Won't fit and they are way too expensive. I am not worried
abotu forward head movement, just side to side. Comment on this proposed
solution please..
mayf
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Land-speed mailing list
http://autox.team.net/mailman/listinfo/land-speed
|