Merry Christmas everyone!
I've got a question about plugging holes in a block. The motor was purchased
assembled and has been run; now it's time to change things over to a dry sump.
The holes that need to be plugged are 3/8" and 3/4", the block's cast iron, and
I'm not tapping them upside down with a shop vac going unless I have to.
I've got an idea or two that would work I suppose. The plugs can be permanent.
I've got a lathe. What say ye, cognescenti? Thanks, BJ in the Bean, where it
finally thawed
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Land-speed mailing list
http://autox.team.net/mailman/listinfo/land-speed
|