Mayf,
Less than .020 should be fine.
I would be much more concerned about stagger.
Bryan
drmayf wrote:
> I am going to purchase a couple of wheels from Diamond Racing Wheels
> because the Goodyear tire folk said my 2 rear wheels had wobbles in
> them. Well, I put the bare wheels on the spindle in front and set up a
> dial indicator. Wobble seems to be over stated, but just for chuckles,
> how much would make a wheel no good? These have 0.010" max for one wheel
> and about 0.016" for the other. That doesn't seem like a lot, but whadda
> I know? Yes, I can call wheel suppliers but I am asking you folk with
> your direct experience. Would you run wheels with this much "wobble"? In
> fact, how many of you actually check the run out to begin with? This is
> not something I would normally do..
>
> mayf
_______________________________________________
Land-speed mailing list
http://autox.team.net/mailman/listinfo/land-speed
|