These numbers are for continuous current. Most cars today have 100 amp or
higher alternators and you never see #4 wire on any of them. You are lucky
to see a #10. This is not telling to use smaller wire this is just an
observation. I use a #8 on my alternator and #1 or 1/0 for batterey cables.
That was the old sizes for 6 volt cars. Use the same size as your battery
cable to ground the engine to the frame. If you use a an ignition box and
mount it on lord or rubber mounts be sure to put an extra chassis ground on
it even if one of the wires comimg out of it goes to a ground...Good Luck
Also If you are smart you will not use crimped fittings. Buy the
noninsulated ones if possible and solder all ends. (you can remove the
insulation) Apply numbered or colored heat shrink over each solder joint
>
> Copper Wire Size Circuit Breaker (amps)
>
> #22 & #20 5
> #18 10
> #16 15
> #14 20
> #12 25 or 30
> #10 35 or 40
> #8 50
> #6 80
> #4 100
> #2 125
>
> Bear in mind that wire temperature will be higher if it is enclosed or
> bundled into a cable. These ratings are only for CB protection of the
> wiring
> itself, not how big a wire you should use for a particular load current.
>
> I hope this may be helpful.
>
> Regards, Neil Tucson, AZ
> _______________________________________________
> gmc6power@earthlink.net
>
> Land-speed mailing list
>
> http://autox.team.net/mailman/listinfo/land-speed
_______________________________________________
Land-speed mailing list
http://autox.team.net/mailman/listinfo/land-speed
|