Without grabing my Machinery handbook I can say that the major diameter of a
3/8-16 bolt is about .370. Very close to 3/8. Not sure what is going on..
----- Original Message -----
From: "Dale Krumheuer" <dmirror3@yahoo.com>
To: <land-speed@autox.team.net>
Sent: Monday, June 18, 2007 1:25 PM
Subject: [Land-speed] Not LSR Question,Need to cut threads to make a 3/8
bolt
> This sounds so eay yet I don't want to buy the wrong size steel rod stock
> (again). I need to cut thread to fit 3/8" 16. I blundered and bought 3/8
> inch stock yet its obviously too large for my die. What size stock should
> I use ?
> Feeling quite humble,
> Dale Krumheuer
>
>
>
>
> Therere no rules of the roadnot even understandings. Craziest is
> king and the contestants are bold.
_______________________________________________
Land-speed mailing list
http://autox.team.net/mailman/listinfo/land-speed
|