Re: GM 3 Bar MAP Sensor

[drmayf <drmayf@mayfco.com>]

Being an old test weinee, I would calibrate so that I could put the data 
into corrrect engineering units with proper accuracy and resolution. maybe.

mayf
todd wrote:

>I'd reccomend putting calibrated(actual) figures in as they all seem to read 
>slightly different(that is if you want actual data), then again.. I'm not 
>Dave.
>Todd
>
>  
>
>>mayf,
>>The output is 0-5 VDC, 0 v = 0 bar and 5 v = 3 bar.
>>Dave,  is this correct?
>>Bryan