I get my Dart little M blocks from a buddy that buys them 10 at a time.
Both Ford and Chevy. Everyone sofar has been right on the spec's. It's a
shame the goofy one had to go all the way to NZ. I can drive 3 miles and
exchsange mine. Anyone else had a goofy one? Doug Odom in big ditch
J D Tone wrote:
> If this is your standard Dart Product I'll keep to my non bent engines
>
>
>>> Referring to the cam bore over their own stated specs they said that
>>> figure
>>
>> was before its final hone. They could supply me a set of slightly
>> oversize OD bearings but didn't consider it justified. They said to
>> purchase oversize cam followers available from Crane to correct the
>> lifter bores.
>> Next they justified the tight crank tunnel by suggesting its easier
>> to take metal out that replace it.
|