Bob;
Here is how Bill Edison formed his Lexan headlight covers:
http://www2.newpaltz.edu/~edison/lights2/index.html
Look about 3/4ths the way down the page in the "Covers" section. Also
click on his "vacuum former" link. Good stuff here!
Regards, Neil Tucson, AZ
-----Original Message-----
From: owner-land-speed@autox.team.net
[mailto:owner-land-speed@autox.team.net] On Behalf Of R. Denton
Sent: Thursday, December 16, 2004 6:24 PM
To: LSR list
Subject: Non LSR Info on Bending lexan
How does one put a permanent bend in a piece of 1/16" lexan? I need to
make covers for for the road racing lights on my Porsche 930. They need
to be curved like the approach to the corners of the front valance.
I assume you do it with heat, but how?
Any and all infor greatly appreciated.
Bob D.
|