I had originally intended to be dishonest and monkey it up. Instead, I
ordered custom pistons (thanks, JE) so that the deck height, compression
ratio, and ring width will not change. Piston weight will change, obviously.
DF
-----Original Message-----
From: DrMayf [mailto:drmayf@teknett.com]
Sent: Tuesday, July 13, 2004 4:58 PM
To: Freiburger, David; 'Keith Turk'; land-speed@autox.team.net
Subject: Re: Bore stroke combinations
Dave, will you do the tests honestly? By that I mean will you only change
rod length on the engine or will you farkle with the compression ratio, cam
timing , valve sizes etc? I really would like to see an honest comparison of
JUSST the variable of rod length. AN dhow will the data be provided? In some
monkeyed up idea of average torque or horsepower? I know each engine can be
optimized for the set of conditions it contains but that isn't the real
question: that is does rod length really do anything for you except empty
your pocket book?
mayf, the red necked ignorant desert rat in Pahrump
----- Original Message -----
From: "Freiburger, David" <David.Freiburger@primedia.com>
To: "'Keith Turk'" <kturk@ala.net>; "'DrMayf'" <drmayf@teknett.com>;
<land-speed@autox.team.net>
Sent: Tuesday, July 13, 2004 5:07 AM
Subject: RE: Bore stroke combinations
> I'm all set to test rod length next.
>
> DF
>
> -----Original Message-----
> From: Keith Turk [mailto:kturk@ala.net]
> Sent: Tuesday, July 13, 2004 5:01 AM
> To: DrMayf; land-speed@autox.team.net
> Subject: Re: Bore stroke combinations
>
>
> Mayf he's played with rod lengths and gone to some extreames to maintain
the
> rod ratio in this test.... to maintain the same compression ratio and to
> truly find out if one combination is better then the other and WHY it's
> better...
>
> Take a minute and assume that the test results were very equal with a
single
> cam and head combination... ( they are both air pumps of equal
displacement
> and equal Valve timing ) and then say.... ahhh okay how do we get more hp
or
> torque out of each combination... what is it that needs to be done to
> optimize a long stroke motor vs a short stroke big bore.
>
> I guess this is our opportunity to design a Camshaft. We know the
> basic's...
>
> Keith ( I have to get scooting here... otherwise I'd look up Freiburgers
> original spec's for the engines )
|