Duhhhh.... So Tonya walks down to check me out and asks what I'm doing.....
and I proceed to explain the whole thing to her.. how you use this chart to
come up with the proper drill bit for the thread size and how some are Fine
and some are course.... and I notice that geez.... Duhhhhh if your doing a
10-24.... you need a bit that is .1495.... if your doing a 10-32... well you
need a bit that measures... . 159.... not that ten thousands makes a
difference or anything....
Yep.... drilled a couple of holes in a bit of flat stock and I'm going to
weld them tabs on here in just a minute... no tapping to it....
Keith ( You tell me Life ain't GOOD )
|