I've talked to a fellow who've had good results forming Lexan by pre
cutting the piece, heating it in an oven and then laying/clamping the
hot sheet over a form. Oven mitts for handling. I can't recall the
temp setting though.
mike
Keith Turk wrote:
> I got some 1/4"
> this time and used a torch to bend it.... unfortunately I was working by
--
Michael D. Siewert
Department of Chemistry, University of Calgary
Calgary, Alberta, Canada
tel. 403 220 7228
fax. 403 289 9488
http://www.ucalgary.ca/~mdsiewer
|