Ed
Don't think the 1/16" difference, between yours and the factory setting,
will make any difference, but I wouldn't go less than 1/16".
JB
----- Original Message -----
From: "Ed Van Scoy" <ed@vetteracing.com>
To: <land-speed@autox.team.net>
Sent: Thursday, August 07, 2003 12:50 AM
Subject: Alignment
> OK, I just finished replacing all the bushings in the Vette's
> rear suspension (4-bar & trailing arms) and now find I have
> excessive Toe. I was gonna set it to 1/16 inch (1/32 on each
> side) but I am wondering if this is enough....... (Stock is
> 1/8 inch) Would appreciate hearing any suggestions & observations.
> Ed
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive
|