Aron,
I have brazed & silversoldered using a TIG...it is just a heat source! Use
argon for a shield.
joe
atrav wrote:
> It should be possible to use a TIG to braze, right? (famous last words)
> I've been searching the Internet, and so far have only found a recommendation
>that with TIG you
> should use a high silicon bronze rod vs. what would be used for gas.
> What I want to know is would you use the same flux, and any other concerns.
>I'm assuming I'd set the
> TIG to negative electrode like with steel, to get a hot surface, but use low
>amps.
>
> -Aron-
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive
|