----- Original Message -----
From: "Waldron, James" <James.Waldron@CWUSA.COM>
> An integral part the water induction system was the installation
> of a spinner with small holes drilled 360 degrees around its
> outer periphery. This spinner (about 3 1/2 to 4 inches in
> diameter) was installed directly in front of the compressor
> impeller and turned several thousand RPM at take off. Water
> introduced through this spinner resulted in no problems
> with water vaporization."
Any more details on this spinner, or pictures?
Thanks,
-Aron-
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive
|