Gotta disagree with that one. Aluminum rods may cycle sooner than steel
rods, but what's a short time? I've had my best success at Bonneville with
aluminum rods and still using them.
JB
----- Original Message -----
From: "Albaugh, Neil" <albaugh_neil@ti.com>
To: "'Keith Turk'" <kturk@ala.net>; "'Scott Cowle'"
<scowle@mentorcollege.edu>; <Land-speed@autox.team.net>
Sent: Thursday, June 05, 2003 1:32 PM
Subject: RE: to buy or not to buy??????
Keith & List;
On the other end of the spectrum are aluminum rods-- they are guaranteed to
fail after a short time. That's OK
for drag racing where they are replaced after only a few runs.
Regards, Neil Tucson, AZ
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|