block boring

[LGMCAFEE@aol.com]

There wasn't much response on warming the block to operating temp before 
boring and honing It must not be done much. We race outboard motors and years 
ago 
a motor builder was doing this is the reason I asked. Sounds like it would 
work for the high end racers.
Larry Mac 

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/land-speed
///  what is needed.  It isn't that difficult, folks.