Jim;
Thanks for the link. That's not the way I'd do it but his approach looks OK,
too. There are commercial torque sensors on the market but they are fairly
expensive.
Regards, Neil Tucson, AZ
-----Original Message-----
From: Waldron, James [mailto:James.Waldron@CWUSA.COM]
Sent: Friday, May 30, 2003 6:36 AM
To: land-speed@autox.team.net
Subject: Horsepower Monitor
For all of the do-it-yourselfers out there. A drive shaft horsepower
monitor.
http://www.circuitcellar.com/flash2002/second.htm
Thanks,
Jim W.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|