no I did understand that it was a real question, and did say "tongue in
cheek". I was not slighting your question in the least, your question is
"good real world and honest". another engine/ring movement question on the
same serious lines as your question, (kind of a stretch though) would be a
rotating radial aircraft engine, where the crank is stationary, and the
block rotates....I don't know the answers, so the questions are asked...
At 10:37 AM 5/30/2003 -0400, you wrote:
>In a message dated 5/30/03 9:59:32 AM Eastern Daylight Time,
>john@engr.wisc.edu writes:
>
>>
>>Tongue in cheek, or in australia?
>>
>>but you have a good real world question, I just don't have an answer....
>
>
>No, that was an honest question, just seams to me that a canted cylinder
>vs a vertical would act differently. Bob in connecticut
John Robinson, Mechanician
Mechanical Engineering University of Wisconsin
1513 University Ave.
Madison, Wi. 53706
608-262-3606
Current World Land Speed Record Holder
Bonneville Salt Flats
H/GCC 92 cu.in. 1980 Dodge Colt
144.396 MPH set 2000
MPS-PG 441 c.c. 1967 BSA Victor Motorcycle
95.193 MPH set 2001
Antarctic Ice Driller Oct02-Jan03
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|