Jack,
You have completely lost me on this one!!! (-:(-:
Skip
At 12:38 PM 4/22/03 -0400, Nt788@aol.com wrote:
>In a message dated 4/22/2003 9:08:27 AM Pacific Daylight Time,
>saltrat@pro-blend.com writes:
>
><< I think you are absolutely correct with the "aero limited vs. power
> limited" observation.....pretty tight trade-off.
> Skip >>
>A chordless Makita drill develops a lot of torque,with a slot car motor, and
>very small gears, only the output shaft is big. It doesn't make enough
>horsepower to remove the screw very fast. If it did the trans would have to
>be tougher. Jack
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|