MLS Gaskets

[Elon Ormsby <ormsby1@llnl.gov>]

Dave Dahlgren said . . . "Yikes with a typical 6" facing mill that is over 
11k SFM.. Talk about going for it!! Sure hope he uses a lot of coolant when 
cutting!!

That is a SFM of only 125 MPH. Must be an "H" motor milling 
machine  :-)    -Elon

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/land-speed
///  what is needed.  It isn't that difficult, folks.