Jack:
1. you might want to use an alloy that has problems if you weld it
2. you might want to avoid post-welding heat-treat
3. you might want to avoid the expense of buying a TIG rig
4. if your name is Costella, you might just want to do something different!
Russ, #1226B
-----Original Message-----
From: Nt788@aol.com [mailto:Nt788@aol.com]
Sent: Thursday, January 09, 2003 12:36 AM
To: rtmack@concentric.net; albaugh_neil@ti.com; ardunbill@webtv.net;
land-speed@autox.team.net
Subject: Re: Welding vs Brazing
In a message dated 1/8/2003 10:22:50 PM Pacific Standard Time,
rtmack@concentric.net writes:
<< Somebody should
do that, so that we will have data to support the use of these options for
LSR chassis. >>
Why would you want to braze a lsr chassis? jack
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|