In a message dated 1/7/2003 7:40:37 PM Pacific Standard Time,
rtmack@concentric.net writes:
<< Apparently, getting those good lugs made for whatever
corner joint you designed was the real problem in brazed-frame fabrication.
Without the lugs, there is hardly any strength, at all.
Russ, #1226B >>
Good point, I had forgotten about lugs! Does 4130 structure change when
welded? It is an alloy! JACK
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|