In a message dated 1/5/2003 12:03:14 PM Pacific Standard Time,
bennevl@bellsouth.net writes:
<< What do I need to do to finish the foam surface to
start laying up fiberglass? Once the the part halves are pulled from the
mold I would just bond the halves together. >>
I would suggest a thick layer of Thalco Green release wax. Match your cuts
tack with Bondo then overlay bond the inside, vee out the outside and do the
same. Don't spend to much time on the mold surface, do your work on the
parts. Jack
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|