In a message dated 1/4/03 5:38:56 AM Central Standard Time,
ddahlgren@snet.net writes:
<<
If the manifold is used it is almost impossible to weld at times. The oil is
way
too deep into the pores..
Like Dave says the metal needs to be clean, I never have had much luck
cleaning aluminum with cleaners. I use a torch and that will bring the oil to
the surface and burn it off also this will preheat the part which will help
in welding if the part is a thick piece. Larry Mac
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|